header

Signal converter incremental >>> analog / serial / parallel for incremental encoders

Here you will find incremental converters that are used to convert counting pulses into analog or parallel standard signals and serial formats. The devices shown are fastened quickly and conveniently to a DIN rail in the control cabinet using snap-on mounting.
There are also other options for converting SSI data with our Series IX display units .

ZP210: Signal converter incremental >>> parallel

The ZP210 signal converter is used to convert pulses into a parallel signal (binary, gray code or BCD format). Pulse inputs A, B [HTL], A, /A, B, /B [RS422, HTL] 3 control inputs (hold) for PNP signals [10 ... 30 VDC] Input frequency up to 1MHz 25-bit parallel output push-pull in BCD, binary or Gray code format

PV210: Signal converter transsonar >>> analog / serial RS232/RS485

The PV210 expands our product segment of transsonar signals with a converter that converts start-stop signals into analog or serial signals.

-Start-stop interface for absolute displacement transducers and magnetostrictive sensors
-Adjustable frequency of the init pulses from 62.5 Hz to 5 kHz
-Analog output ±10 V, 0/4 ... 20 mA, 16 bit
-USB interface and RS232/RS485 interface for configuration and serial reading

Document