The signal converters shown here serve special requirements, such as the conversion of absolute SSI encoder signals into an analog standard signal as well as into a serial or parallel format. You can also find the right product here for converting parallel BCD, binary or Gray codes into serial formats. All signal converters shown below are intended for installation in a control cabinet on a top-hat rail and have a corresponding snap-on mechanism that enables quick and easy installation without additional accessories. There are other options for converting SSI data with our SSI displays or fiber optic modules .

The IP210 signal converter accepts signals via its SSI input and converts them into a parallel binary, gray code or BCD format.

-SSI input in the format DATA+, DATA-, CLOCK+, CLOCK- up to 32 bits
-3 control inputs (hold) for PNP signals [10 ... 30 VDC]
-Input frequency up to 1MHz
-25-bit parallel output push-pull in BCD, binary or Gray code format

Signal converter with SSI interface for processing absolute position values ​​into current and voltage values. Functions such as wire break monitoring, bit masking, concentricity function, scaling, etc.

-SSI input DATA+, DATA-, CLOCK+, CLOCK- [RS422], 32 bit
-SSI clock frequency up to 1 MHz
-Analog output ±10 V, 0/4 ... 20 mA, 16 bit
-USB interface and RS232/RS485 interface for configuration and serial reading

Extremely powerful signal converter for converting SSI absolute values ​​and serial data into a parallel binary, gray code or BCD format.

-SSI input in the format DATA+, DATA-, CLOCK+, CLOCK- up to 25 bits
-Clock frequency up to 1 MHz
-Control input (hold) for PNP signals [10 ... 30 VDC]
-25-bit parallel output push-pull in BCD, binary or Gray code format

Encoder switch for contactless and bounce-free switching from two SSI sensors to an SSI master. Can be cascaded by other devices.

-2 SSI input in the format DATA+, DATA-, CLOCK+, CLOCK- [RS422]
-Cut-off frequency 100 kHz ... 1 MHz
-1 SSI output in the format DATA+, DATA-, CLOCK+, CLOCK- [RS422]